2.2.1 Using the Configuration Worksheet
While you are researching the details needed to successfully configure and start the TCP/IP
stack, use the configuration worksheet shown below to document your installation. Once you
have completed this worksheet, verify the information by discussing it with any coworkers,
consultants or service providers who are knowledgeable about TCP/IP configuration issues and
your network.
Figure 2.1 The configuration worksheet.
LAN DRIVER INFORMATION
|
|---|
LAN Driver Filename: _______________________________________
|
LAN Driver LOAD parameters: ________________________________
|
LAN Topology/Medium: ( ) Ethernet ( ) Token Ring ( ) FDDI
|
Frame Type for TCP/IP: ( ) ETHERNET_II ( ) TOKEN-RING_SNAP
|
Name to Assign this Frame Type: ____________________________
|
|
TCP/IP INFORMATION
|
IP Address for this System: ________________________________
|
Subnet mask for this System: ______________________________
|
Routing Protocol: ( ) None ( ) Static ( ) RIP ( ) OSPF
|
Default Route (STATIC ONLY): _______________________________
|
|
NAME SERVICE INFORMATION
|
Hostname for this System: __________________________________
|
Domain Name for this System: _______________________________
|
Primary DNS Server: ________________________________________
|
Secondary DNS Server: ______________________________________
|
Tertiary DNS Server: _______________________________________
|
The configuration worksheet will be referred to throughout this manual.
An example of a completed worksheet is shown in Figure 2.2 below:
Figure 2.2 Sample configuration worksheet
LAN DRIVER INFORMATION
|
|---|
LAN Driver Filename: SMC8000.LAN
|
LAN Driver LOAD parameters: PORT=300 INT=3 MEM=CC000
|
LAN Topology/Medium: (X) Ethernet ( ) Token Ring ( ) FDDI
|
Frame Type for TCP/IP: (X) ETHERNET_II ( ) TOKEN-RING_SNAP
|
Name to Assign this Frame Type: SMC-TCPIP
|
|
TCP/IP INFORMATION
|
IP Address for this System: 192.168.1.20
|
Subnet mask for this System: 255.255.255.0
|
Routing Protocol: ( ) None (X) Static ( ) RIP ( ) OSPF
|
Default Route (STATIC ONLY): 192.168.1.1
|
|
NAME SERVICE INFORMATION
|
Hostname for this System: GREYWOLF
|
Domain Name for this System: UNOVERICA.COM
|
Primary DNS Server: 192.168.1.10
|
Secondary DNS Server: 192.168.1.15
|
Tertiary DNS Server:
|
STEP: To continue to the next step in the configuration process, go to section 2.2.2 Determine
the LAN Driver Information.
Copyright © 1997, Unoverica Corporation. All rights
reserved. Unauthorized use prohibited.
Send comments to docs@unoverica.com