Chapter 3: Installing and Starting Unoverica Message Transport

3.3 Installing Unoverica Message Transport

NOTE: If you are upgrading from a previous version of Unoverica Message Transport, then you must first stop the existing Unoverica Message Transport server. Instructions for stopping the Unoverica Message Transport server are detailed in section 3.4 Starting and Stopping Unoverica Message Transport.

Installing Unoverica Message Transport consists of the following three steps:

1. Copy the installation software to the server, or to a floppy disk that can be used on the server, or to a workstation that can be used as a remote installation system with NetWare 4.x’s INSTALL.NLM utility. For more information on this subject, refer to section 3.3.1 Extract the Installation Files.
   
   
2. Load NetWare’s INSTALL.NLM utility, and begin the installation procedure. For more information on NetWare’s INSTALL.NLM, refer to section 3.3.2 Using NetWare’s INSTALL.NLM.
   
   
3. Install Unoverica Message Transport, and enter the license key information provided by Unoverica Corporation. For more information on this subject, refer to section 3.3.3 Unoverica Message Transport’s Installation .
   

STEP: To continue to the next step in the installation process, go to section 3.3.1 Extract the Installation Files.

Copyright 1997 Unoverica Corporation. All Rights Reserved page
Send comments to docs@unoverica.com